Booster Pump System Power Station for Reefkeepers

City and well water pressure can range from 30 PSI to 55 PSI .... The ideal water pressure for an RO system is 60 PSI and thus increasing by increasing your psi up to this level the more efficient the RO system will be .... So Super Charge your ReefKeeping system.... Drive the output quantity and water quality too new heights.... The power station can supply .5 GPM at 60 psi to your ReefKeeping reverse osmosis system.... Every feature you will ever need is included.... You can use the power station to drive (35-150) gallon per day systems.We do not like to add the Booster Pump on to household pressure which already exceed 50 psi, as this is sufficient pressure to make water and the extra cost/work of adding a booster pump is not generally worth the effort.
You do not have to re-plumb your system. Simply connect the power station in the water supply line and connect your reefkeeper inlet to the power station. Connections are quick connect. This is an "on-demand" system which shuts itself down once the desired psi water pressure has been achieved. Here is what you get: Sediment filter stops small dirt particles that could ruin your pump.In-line check valve prevents higher pressure water from backing up into your plumbingThe .5 gpm @ 60PSI quiet running booster pump .(Please limit pressure to 65 psi.). The pumps maximum capacity of 100 PSI can be reduced downward by a simple adjustment to the brass needle valve which is included. Adjustable high pressure cut out switch. The Allen wrench to make this adjustment is included.Our exclusive flow control locking needle valve to balance your existing pressure with the boosted pump water pressure. Low voltage transformerA 60 PSI water pressure gauge You can be up and running in no time at all. We have connected and hooked up everything and supplied everything you need . This is a virtual plug & play system ... Installation note: this pump has been set up to be placed in front of your RO unit; some folks have had better success by installing it AFTER the pre-filters and just before the water goes into the membrane. Just takes a little tubing to install this way, as all of the fittings that come with this unit can be re-used for this configuration. The power station can easily pressure up a 60 gpd system to full operational operating pressure. Most RO systems can expect a 15 to 20 psi boost in water pressure . Do not use with systems larger than (150) gpd .